Fix NAT
R1 should give the whole LAN internet access with PAT on Gi0/1, and publish SRV (192.168.1.100) as 203.0.113.5. Right now nobody can reach the internet and REMOTE can't reach the server. Find and fix every fault.
How it works: this is VulnTech NetLab, a network simulator running in your browser. Click a device in the diagram to open its console and type commands, just like on real equipment (? shows help, Tab finishes a word). Click a cable to inspect it. Tasks tick themselves off as you complete them; questions are answered in the box under each task. Your work is kept if you reload; Reset starts the network over.
Solution explanation
Three faults. Inside and outside were swapped, so nothing was translated. R1 had no default route, so nothing could be routed out at all (NAT only happens to packets that are routed). And ACL 1 used the wildcard 0.0.0.15, which only matches 192.168.1.0 to .15: PC1 (.10) would have worked, but PC2 (.20) and PC3 (.30) were never translated. A /24 needs 0.0.0.255. (SRV doesn't need the ACL: its static mapping comes first.)
Show solution
[R1]
enable
show ip nat statistics | begin Outside
show ip route | begin Gateway
show access-lists 1
configure terminal
interface g0/0
no ip nat outside
ip nat inside
interface g0/1
no ip nat inside
ip nat outside
exit
ip route 0.0.0.0 0.0.0.0 203.0.113.1
no access-list 1
access-list 1 permit 192.168.1.0 0.0.0.255
end
clear ip nat translation *
[PC1]
ping 198.51.100.10
[PC3]
curl http://198.51.100.10
[REMOTE]
curl http://203.0.113.5