Publish a server with static NAT
The company web server SRV (192.168.1.100) must be reachable from the internet as 203.0.113.5. Set up static NAT on R1: Gi0/0 is the inside, Gi0/1 the outside. Test from REMOTE, out on the internet.
How it works: this is VulnTech NetLab, a network simulator running in your browser. Click a device in the diagram to open its console and type commands, just like on real equipment (? shows help, Tab finishes a word). Click a cable to inspect it. Tasks tick themselves off as you complete them; questions are answered in the box under each task. Your work is kept if you reload; Reset starts the network over.
Solution explanation
203.0.113.5 stands for an inside host on the outside, so it's the inside global address; 192.168.1.100 is the inside local. The ISP can reach 203.0.113.5 because it's in the 203.0.113.0/29 link network: R1 answers ARP for it on Gi0/1.
Show solution
[R1]
enable
configure terminal
interface g0/0
ip nat inside
interface g0/1
ip nat outside
exit
ip nat inside source static 192.168.1.100 203.0.113.5
end
[REMOTE]
curl http://203.0.113.5
ping -c 2 203.0.113.5
[R1]
show ip nat translations